[Help] Connecting continuous water filter supply to 5 gallon bottle attached to a dispenser

The whole idea is to stop wasting time in removing the bottle from the dispenser, filling the bottle, and then doing the heavy lifting/spilling and connecting the bottle back to the dispenser.

Something like this: http://ift.tt/1IBCFfa

I have googled but couldn't find any kit that I could buy to achieve what I want.

I found a patent that seems helpful: http://ift.tt/1DYVdAG

The other bit of help I received was from this Yahoo! Help post:

Cut a hole in a bottle towards the top.

Install a 1/4" bulkhead fitting in the hole.

Install a solenoid in your 1/4" water line.

Install a float level switch in the modified bottle.

Wire the solenoid coil through the float switch.

and this (which is very complicated): http://ift.tt/1DYVfIF

Did anyone here deal with this type of project before.

Please guide me on where to start. Is there any kit available that does the job? Or should I look into building one for myself. Any ideas, or guides will be very helpful.

Thanks

Submitted August 01, 2015 at 08:28PM by OMDB-PiLoT http://ift.tt/1DYVdAD